Instructions

Please Note: Ezy-As™ is an assistive device only. Its unique design has made it possible to assist in the fitting of wide range of compression garments. For the final positioning on the limb of any such garments, please refer to the information supplied by the garment manufacture.

Steps for loading the applicator

Place your Ez-As™ stocking applicator on a suitable surface with the enlongated hole facing you. Place your compression stocking inside the U-shaped Ezy-As, with the heel of the stocking facing the enlongated hole.

Pull the top of the stocking over the ezy-as and slide it down the sides.	Continue to slide the stocking onto the applicator.	Stop when the placement of the heel is slightly over the top and in the center of the U-section.

Steps for using the Applicator on lower limbs

Note: It may be required to position the heel over further depending on your foot or stocking type.

While seated, place your applicator over your toes. Hold the heel pocket as your toes enter the stocking.	Release the heal pocket of the stocking when it is in line with your heel.	Continue moving the applicator over your foot and your heel will slide into the elongated hole as the applicator changes direction around your ankle.

Gently pull the applicator towards your Knee.	Your ezy-as applicator is then removed when free of the stocking.

Note: In cases where a Full Leg stocking is required, fit the lower portion as shown, then remove your applicator at the base of your knee by simply moving it backwards. Then pull the upper portion of the stocking into place by hand. After the fitting, be sure the heel of the stocking is properly placed on your foot. Smooth out any wrinkles by stroking with the palm of your hands.